cisco nexus fex windows server 2016 lacp

To get to NIC Teaming, you have to get into “ Server Manager” and then click on “ Local Server“:īelow, the NIC Teaming is Enabled (it will say disabled if it was never setup or disabled): One last note, for the “ Load Balancing mode“, it’s best to keep it at “ Dynamic“. I’m going to get into the difference algorithms but ‘usually” with these configurations, it’s best to use src-dst-ip algorithm to match the VM side. Use this when going to two distinct switches Uses LACP to dynamically identify links that are connected between the host and the switch This means it will not detect cabling or other errors that could cause the Team to fail.ĭescription NIC Team for Windows Server 2016 Links are hard-coded so there’s no additional protocols to assist. Requires configuration on BOTH the switch and the host The key is that if you are going into two distinct switches and you want to port-channel, you have to be using a technology that logically represents the switch as ONE like when you have Cisco switches stacked or if you’re running VPC/VSS. On the Cisco side, here are you options with the correct teaming mode:Ĭisco Stack Switch – Static Teaming or LACP You want the NIC to go to different different switches whenever possible.

Now another common issue you’ll see or have to explain is when you go design where the two Server NICs plug into. As you can probably guess, “ Switch Dependent” basically means it relies/depends on a Switch configuration while “ Switch Independent” does not. I think the most important thing about these modes that people overlook is the fact that you have “ Switch Dependent” and “ Switch Independent“.

LACP (Switch Dependent – requires a switch configuration) Static Teaming (Switch Dependent – requires a switch configuration)ģ. I’m writing this post because you’ll walk into environments and the NIC Teaming is not setup correctly.ġ.

Cisco nexus fex windows server 2016 lacp